25
EN
The device will start vacuuming immediately.
3. Move the nozzle over the surface to be cleaned.
4. Switch off the device after vacuuming.
5. Empty and clean the dust container (
8
) (see the “Cleaning and Storage” chapter).
Cleaning and Storage
PLEASE NOTE!
■
Make sure that the device is switched off before cleaning it!
■
Only reassemble the device once all of the parts are completely dry!
■
Do not use any sharp or abrasive cleaning agents to clean the housing. They could
damage the surfaces. Clean the housing with a slightly damp, soft cloth if necessary.
The motor
fi
lters may lose some of their colour over time. This is normal and
does not have any adverse effect on function.
Emptying the Dust Container
1. Remove the dust container (
8
) from the motor unit (
3
) (see the “Assembly” chapter –
“Removing / Inserting the Dust Container”).
2. Hold the dust container over a dustbin.
3. Press the release button (
B
) for the bottom of the dust
container. The bottom of the dust container will open and
the dirt will fall out.
4. Flip the bottom of the dust container shut again. The catch
must be heard to engage in place.
5. Insert the dust container into the motor unit (see the “Assem-
bly” chapter – “Removing / Inserting the Dust Container”).
Cleaning the Dust Container, Cyclone Insert and Filters
1. Remove the dust container (
8
) from the motor unit (
3
) (see the “Assembly” chapter –
“Removing / Inserting the Dust Container”).
2. Twist the lid (
12
) anticlockwise until the arrow (
C
) on the
dust container lid points to
OPEN
on the dust container,
and take off the lid.
3. Remove the
fi
lter holder (
E
) with motor
fi
lters.
4. Remove the
fl
eece motor
fi
lter (
D
).
Please Note:
The second motor
fi
lter is
fi
rmly attached
to the
fi
lter holder and cannot be taken out of the holder!
B
C
E
D
