25
EN
Emptying the Dust Container and Cleaning Filters
1. Remove the dust container (
7
) from the motor unit (
3
).
Turn it a little to do this. It is released from the motor unit
and can be removed.
2. Remove the foam
fi
lter from the top of the dust container,
tap it out and clean it with a soft brush if necessary.
3. Hold the dust container over an open dust container. The
distance from the dust container should be as small as
possible so that the dust does not spread in the surroun-
ding air.
4. Pull the catch of the bottom
fl
ap (
e
) away from the dust
container slightly. The bottom
fl
ap will open and the dirt
will fall out.
5. To close it, press the bottom
fl
ap onto the dust container.
The catch must be heard to engage in place.
Cleaning the HEPA
fi
lter and the
fi
lter holder
1. Empty the dust container (
7
) (see above). Do not close the bottom
fl
ap (
e
).
2. Reach into the dust container. Turn the
fi
lter holder (
g
) a little until it is released and
can be removed.
3. Pull the HEPA
fi
lter (
g
) out of the
fi
lter holder.
4. Tap out both parts and clean them with a soft brush if
necessary.
5. The
fi
lter holder can also be rinsed with clear water.
NOTICE:
Do not wet-clean the HEPA
fi
lter!
6. Wipe out the dust container with a damp cloth if necessary.
7. Let all parts dry completely in the air before you reassemble them.
NOTICE:
Never
assemble wet or damp components or attach them to the motor unit
(
3
)
!
The
device is assembled in the reverse order.
Cleaning the Main unit, Articulated Suction Tube and Nozzles
• Wipe down the main unit (
3
), articulated suction tube and nozzles with a damp, soft
cloth if necessary. Then dry them with a soft cloth.
• Regularly remove hair and
fl
uff from the nozzles and brushes.
Cleaning the electrical
fl
oor nozzle
To make it easier to clean, the brush can be removed from the electrical
fl
oor nozzle (
9
):
1. Slide the latch fastener on the bottom of the electrical
fl
oor nozzle towards the small wheel on the electrical
fl
oor
nozzle.
open
closed
e
f
g
