CleanCraft KM 625, Operating Instructions Manual

Page: 16 / 26

16 KM Series | 1.02
Troubleshooting
15 Troubleshooting
15.1Display error codes
15.1.1 Programming
Your machine has factory set for optimal operation so no
further adjustments are necessary. However, if any of
the following codes appear: P1.x, P2.x or SF.x (x= value
between 0 and 9), follow the programming instructions to
reset the display. Operating the machine with settings
other than the factory settings may cause operational
problems.
15.1.2 Programming guide
If the display indicates P1.0, P2.1 or SF.3, switch the
machine off and on again to reset the display (these are
the factory settings). If the display shows higher values
than above (e.g. P1. "5", P2. "7", SF. "9"), proceed as
follows:
To call up the factory settings, switch on the machine,
press the display switch and hold it pressed for at least 3
seconds (battery/time symbols). P1.x will appear on the
display. The value P1 should be "0" (e.g. P1.0). If the
value is greater than "0", press the intake fan push but-
ton until P1.0 appears on the display. Press the display
switch again to display the next code. The value P2.x
should be "1" (e.g. P2.1). Press the push button of the in-
take fan to achieve the correct setting. Press the display
button to show the last code. The code should be SF.3. If
the value is not "3", press the filter shaker button until
SF.3 appears on the display. To exit the programming
function, switch off the machine.
NOTE!
If you cannot fix the problems with your sweeper by
yourself, please contact your local Cleancraft dealer.
Please write down the following information regarding
the sweeper or the operating instructions so that we
can support you in the best manner.
- Model name of the machine
- Serial number of the machine
- Year of manufacture
- Exact description of the error
Fault Remedy
Unsatisfactory
sweeping result 1. Empty the dirt collection con-
tainer
2. Adjust the height of the main
brush
3. Clean or replace the main
brush
4. Replace drive belt
5. Adjust / replace / clean side
brush
6. Adjust the height of the side
brush
Code Fault Remedy
C22 Protection of the
sweeper roller
against short-cir-
cuits: All functions
stops. Switch the machine
OFF and then ON
again.
C14 Heat dissipator for
high temperatures.
Switches on at a
temperature above
90 °C. The machine is re-
set as soon as the
temperature drops
below 80 °C.
FS0 Roller/brush worn
out. Replace roller/
brush.
SP1 Defective brush. Is activated when
the brushes stop
three times within
one minute. Fault
can be reset by
switching off the
machine.
Yellow
LED
lights
up
Reserve state of
the battery You can continue
operating the ma-
chine. Just for refe-
rence, the battery is
being charged.
Red
LED
flashes
Empty battery All machine functi-
ons are interrupted.
Switch off the ma-
chine and charge
the battery.
P1.X Push-button pro-
gramming of opera-
ting mode 1 activa-
ted. See "programming"
chapter below
P2.X Push-button pro-
gramming of opera-
ting mode 2 activa-
ted. See "programming"
chapter below
SF.X Filter shaker pro-
gramme setting is
activated. See "programming"
chapter below
Code Fault Remedy