CleanCraft KM 625, Operating Instructions Manual

Page: 14 / 26

14 KM Series | 1.02
Care, Maintenance and Repair
13.2 Maintenance and Service/Repair
Regularly check the belt of the machine for good fit. Re-
place the belt if it is worn.
Regularly check the brushes for wear and replace them if
necessary.
Maintenance intervals:
If the hand sweeper does not work properly, contact a
specialist dealer or our customer service. You will find
the contact details in chapter 1.2 Customer service.
13.2.1 Replacing the sweeping brush
Step 1: Switch off the machine.
Step 2: Lift the machine at the front.
Step 3: Press in the two tabs on the sweeping brush and
pull it out downwards.
Step 4: Insert the new sweeping brush and press it in un-
til it is locked in place.
Fig. 13: Replacing the sweeping brush
ATTENTION!
Maintenance and repair work must always be carried
out by qualified personnel; any damaged parts may only
be replaced with original spare parts.
ATTENTION!
Unplug the battery and the charger before carrying out
maintenance work on the machine.
On del
iv
e
ry
Da
ily
Every 10
hours
Every 20
hours
Every 50
hours
Every 100
hours
Check the functionality of all
components
X X X X X X
Empty and clean the dirt col-
lection container
X
Remove and clean the pre-fil-
ter
X
Check the seals X
Check the main filter (clean, if
necessary)
X
Check bolts and nuts for tight-
ness
X
Check wear of the rollers and
brushes
X
Check the belt tension X
ATTENTION!
Maintenance and repairs must always be carried out
by qualified personnel. Any damaged parts must only
be replaced with original spare parts.