Repair or Warranty Contact
Clayton Associates, Inc. • 1650 Oak Street • Lakewood, New Jersey 08701 • P.+1-732-363-2100 F.+1-732-364-6084
WC-0
Page 8
5.
Verify the HEPA filter is seated.
• Holding the power head on its side, examine the HEPA Filter.
•
Verify the white inner ring of the HEPA filter is fully seated against the underside of the power head.
–
If it is not, rotate it clockwise until fully seated.
6. Replace the power head.
• Position the power head on the tank.
• Rotate the power head so that the power switch on the power head is aligned with the inlet port on the vacuum tank.
• Latch the power head to the tank.
If this vacuum is used to collect hazardous material, appropriate personal protective equipment may be required.
Replace the pre-filter every five (5) bag filter changes or when it becomes visibly dirty.
1. Safe the vacuum.
• Disconnect the vacuum from the power source.
• Remove all hoses from the vacuum.
2. Remove the power head.
• Unlatch the power head from the tank.
•
Lift the power head and the attached HEPA filter off the tank using the top handle.
•
Carefully place the power head on the floor – avoid damaging the HEPA filter.
3.
Remove the pre‑filter.
•
The pre-filter is wrapped around the HEPA filter and secured with Velcro.
• Find the seam and carefully peel the Velcro apart.
•
Dispose of the pre-filter according to company policy.
4.
Install a new pre‑filter.
•
Unfold a new pre-filter and remove the thin Velcro cover strip from the Velcro hooks.
•
Wrap the pre-filter tightly around the HEPA filter.
•
Secure the pre-filter by adhering the Velcro hooks to the side of the pre-filter.
5.
Verify the HEPA filter is seated.
• Holding the power head on its side, examine the HEPA Filter.
•
Verify the white inner ring of the HEPA filter is fully seated against the underside of the power head.
–
If it is not, rotate it clockwise until fully seated.
6. Replace the power head.
• Position the power head on the vacuum tank.
• Rotate the power head so that the power switch on the power head is aligned with the inlet port on the vacuum tank.
• Latch the power head to the tank.
BAG FILTER CHANGE
PRE-FILTER CHANGE
