Repair or Warranty Contact
Clayton Associates, Inc. • 1650 Oak Street • Lakewood, New Jersey 08701 • P.+1-732-363-2100 F.+1-732-364-6084
WC-0
Page 7
1. Attach the vacuum hose.
• Open the Inlet Port on the vacuum tank.
• Insert the metal sleeve of the vacuum hose into the Inlet Port on the vacuum tank.
2. Plug the power head/vacuum into an appropriate outlet.
3. Activate the vacuum.
• Toggle the power switch to the ON position.
If this vacuum is used to collect hazardous material, appropriate personal protective equipment may be required.
The bag filter should be replaced when ¾ full.
1. Safe the vacuum.
• Disconnect the vacuum from power source.
• Remove all hoses from the vacuum.
2. Remove the power head.
• Unlatch the power head from the tank.
•
Lift the power head and the attached HEPA filter off the tank using the top handle.
•
Carefully place the power head on the floor – avoid damaging the HEPA filter.
3.
Remove the filter bag.
•
Grasp the cardboard collar of the bag filter and slide it off the inlet port on the vacuum tank.
• Holding your hand over the opening on the bag, lift the bag out of the tank.
• Dispose of the bag according to company policy.
4.
Install a new filter bag.
•
Unfold and fluff a new filter bag.
•
Push the inlet tube into the hole on the cardboard collar of the filter bag.
• Grasp the sides of the cardboard collar and push it all the way onto the inlet tube.
• Verify the bottom of the collar is past the opening on the underside of the inlet tube.
continued on next page
BEFORE EACH USE
BAG FILTER CHANGE
GL_005
Tank Wall
Tank Wall
Bottom and top of
cardboard bag collar
must be flush to tank
Push cardboard bag
collar past this point
Filter Bag
