Repair or Warranty Contact
Clayton Associates, Inc. • 1650 Oak Street • Lakewood, New Jersey 08701 • P.+1-732-363-2100 F.+1-732-364-6084
WC-0
Page 6
Prepare the vacuum for use.
1.
Install a filter bag on the tank.
•
Unfold and fluff a new filter bag.
•
Push the inlet tube into the hole on the cardboard collar of the filter bag.
• Grasp the sides of the cardboard collar and push it all the way onto the inlet tube.
• Verify the bottom of the collar is past the opening on the underside of the inlet tube.
2.
Unbox a new HEPA filter.
• Remove the Clayton HEPA timer card from the box and set aside.
• Remove the HEPA cable lock from the box and set aside.
•
Remove the HEPA filter from the box and remove from plastic bag.
3.
Install a new HEPA filter.
•
Holding the power head on its side, screw the new HEPA filter onto the filter adapter.
•
Verify the white inner ring of the HEPA filter is fully seated against the underside of the power head.
–
If it is not, rotate it clockwise until fully seated.
• Refer to the instructions included with the HEPA cable lock to install the cable lock.
4. Attach the power head.
• Position the power head on the tank.
• Rotate the power head so that the power switch on the power head is aligned with the inlet port on the vacuum tank.
• Latch the power head to the tank.
5.
Activate the HEPA filter timer.
• Attach the new HEPA timer card with a zip tie (included) to the top handle of the vacuum.
• Follow the directions on timer card to activate it.
GETTING STARTED
GL_005
Filter Bag
Bottom and top of
Cardboard Bag Collar
must be flush to tank
Push Cardboard Bag Collar
past this point
Tank Wall
Tank Wall
