G3 Display 006-00001GF
4
Clayton Power R&D, s.r.o. 006-00001DSF rev.003
1
Features
•
Remote control of up to four G3 combi or inverter
•
Wide supply voltage range 8-35VDC
•
Single wire communication with up to four G3 units
•
Low power consumption >5mA in standby mode (without back light)
•
Low sleep mode consumption >100uA
•
Firmware update over PC
2
Installation
2.1
Safety instructions
Installation must strictly follow the national safety regulations in compliance with the
enclosure, mounting, creepage, clearance, casualty, markings, and segregation
requirements of the end-use application. The installation must be performed by
professional installer only. Switch off the system and check for hazardous voltages
before altering any connection!
Ensure that both units are switched off during the
wiring of G3 display to Inverter/Charger/Combi!
2.2
Wiring
The maximal length of cables between the G3 display 006-00001GF and
Inverter/Charger/Combi is 5 meters. Use the wire AWG18 with rating of 300VAC for
the connections. The temperature rating of cables has to be minimum 80°C or higher
(according to end-use application)
2.3
Connectors Pinout and Location
Figure 1: Location of connectors on rear panel of G3 Display
