ENGLISH
26
Fault
Possible
Causes
Remedy
When the
main switch
is pressed the
machine does
not turn on.
The machine has
no power supply.
Check the socket
with another
device and insert
the mains plug
correctly.
The service door
is open.
Please close the
door.
Percolation
does not start.
Coffee grounds
collector (8) is
not correctly
inserted.
Insert the coffee
grounds collector
correctly.
The water tank is
empty.
Fill the water tank.
The device is in
steam extraction
mode.
Turn the machine
back to normal
mode.
The brew group
is not correctly
inserted.
Insert the brew
group correctly (see
section „Position of
the Drive Shaft“).
In the coffee
preparation
cycle the noise
of the grinding
mechanism be-
comes louder.
The coffee beans
are used up.
Switch off the de-
vice and fi ll up the
container (2).
No hot water/
no steam
Hot water/steam
nozzle (14) is
blocked.
Unblock the
opening with a thin
needle.
No coffee
comes out, but
there is no error
message in the
display.
The water
system has not
been fi lled with
the water from
the tank.
Follow the instruc-
tions in the section
on „Initial Use“
carefully.
No coffee
comes out /
the coffee only
comes out
slowly.
The coffee spout
(13) is blocked.
Switch off the
machine. Clean the
coffee spout and
the fi lter (diagram
B) in accordance
with the instruc-
tions in the section
“Cleaning and
Maintenance”.
The water sys-
tem is blocked
by lime.
Carry out descaling
and cleaning.
Degree of grin-
ding too fi ne.
If the problem per-
sists, set a coarser
degree of grinding
(see section „Set-
ting the Degree of
Grinding”).
The heating
time becomes
longer, the
warm water
quantity smal-
ler.
The device is
furred up.
Start the descaling
programme.
Fault
Possible
Causes
Remedy
The coffee is
not creamy
enough.
The coffee mix-
ture used is not
suitable.
Try different coffee
mixtures.
Degree of grin-
ding too coarse.
Set to a fi ner de-
gree of grinding.
The milk is not
foamed.
The milk is not
suitable.
Check the fat
content. Use low
fat milk.
The brew group
becomes stuck
in the service
chamber.
The start and
end position of
the brew group
do not corres-
pond to the start
position of the
drive shaft.
Switch the machine
on and off at least
fi ve times in a row.
Before switching
off each time allow
the adjustment
procedure of the
machine to fi nish -
loud clicking noises
are normal. Before
switching on again
each time please
check whether the
brew group has
come loose.
Technical Data
Model:
KA-V 2936
Rated voltage/frequency:
230 V ~ 50 Hz
Power consumption:
1300 W
Protection class:
Ι
Water tank:
1,4 l
Coffee bean container:
250 g
Coffee grounds container:
0,6 l
Dimensions
(W x H x D):
approx. . 34.2 x 26.6 x 36.7 cm
Weight:
approx. 9 kg
This device has been tested according to all relevant
current CE guidelines, such as electromagnetic com-
patibility and low voltage directives, and has been
constructed in accordance with the latest safety
regulations.
Subject to technical changes without prior notice!
05-KAV 2936 GB 26 03.12.2004, 12:13:33 Uhr
