Preparing the Remote Control
Inserting the Batteries A
When inserting the batteries ensure that the (+) and (-)
poles are correctly aligned as shown in the diagram.
Lifetime of the Batteries
•
The batteries will normally last for approximately one
year; however this depends on the frequency and type
of use of the remote control.
•
If the remote control does not work even if held close
to the device, the batteries need to be replaced.
•
Use batteries of size UM-3.
Important:
•
Do not use any rechargeable (Ni-Cd) batteries.
•
Do not try to recharge, short-circuit, disassemble or
heat batteries or throw them into the fire.
•
Do not drop the remote control or subject it to any
other impacts. This could damage internal parts or re-
sult in malfunctions.
•
Do not mix old and new batteries.
•
If the remote control is not going to be used for a pro-
longed period, please remove the batteries. Otherwise
electrolyte could leak out of the batteries, causing not
only malfunctions, but also burns on contact with the
body.
•
Wipe off all electrolyte residues from the remote con-
trol and install new batteries.
•
If your body should come into contact with electrolyte
in any way, wipe it off carefully with water.
Please Note!
Old batteries should not be thrown into the domestic wa-
ste! Please return them to a place where they can be
recycled or disposed of properly.
Operating Range of the Remote Control B
Hold the remote control at a distance of not more than
approximately 7 m from the remote control sensor and
within an angle of approximately 60° to the front of the
device.
•
The operating range may vary depending on the
brightness of the room.
Important:
•
Do not point any bright lamps at the remote control
sensor
•
Do not place any objects between the remote control
and the remote control sensor.
•
Do not use the remote control of this device while you
are using the remote control of another device at the
same time.
Playing Back Audio CDs
•
Turn on the power switch. Then press the standby but-
ton followed by the OPEN/CLOSE button in order to
open the CD compartment. Insert an audio CD with
the label facing upwards into the CD compartment.
Press the OPEN/CLOSE button again to close the CD
compartment.
•
The device reads the content of the CD and begins to
play it back automatically.
•
In order to read CD information such as the number of
tracks and playing time on the television screen
(OSD), press the DISPLAY button.
•
Press the SKIP +/- buttons to select the previous or
next track. You can also select a track directly using
the number keys.
28
DVD 582 - GB 30.09.2003 12:31 Uhr Seite 28