14
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
MAINTENANCE
DAILY
1. Before use, drain water from the air tank, air line and compressor.
2. If no airline lubricator or mini oiler is used, ensure that oil is applied to the air
tool on a daily basis through the air inlet connection. Run a few drops of oil
through the tool before use. It may be entered into the air inlet, (ensuring
the strainer is clear), or into the hose at the nearest connection to the air
supply.
3. This procedure should be repeated after every two to three hours of use or
at the start of the working day.
4. Keep the body of the air tool clean and free from debris.
WEEKLY
1. Check the air inlet screen filter for
blockage and clean if necessary.
CLEANING
1. Grit or gum deposits inside the air
tool may also reduce its
efficiency.
2. After extensive use, remove the
inlet screen filter and flush out the
mechanism with gum solvent oil or
an equal mixture of CLARKE air-line oil and paraffin. Allow to dry before
use.
SERVICE AND REPAIR
1. If the tool runs erratically or becomes inefficient although the air supply is in
good order, it may be necessary to dismantle the air motor and replace
any worn or damaged parts. Such servicing and repair work should be
carried out by a qualified service technician.
WARNING: MAKE SURE THAT THE AIR TOOL IS DISCONNECTED FROM THE
AIR SUPPLY BEFORE STARTING ANY CLEANING OR MAINTENANCE.
Summary of Contents for X-PRO CAT208
Page 24: ......
