12
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
3. Squeeze the trigger against the
body of the air tool to start.
4. Release the trigger to stop the tool.
5. Always ensure the air tool has
stopped before putting it down.
6. When releasing very tight
fastenings initially break loose by
hand. Squeeze the trigger and the
air tool will complete the job.
7. If necessary, use penetrating oil to assist in freeing off rusted fasteners.
8. When assembling, start turning fasteners by hand, then set the rotation
forward or reverse. Apply the air tool gently and squeeze the trigger to
tighten with power.
9. Final tightening should be completed by hand, using a torque wrench if
needed.
DISCONNECTING THE AIR SUPPLY
1. Do not disconnect the air hose until the supply is isolated at a shut-off
valve.
2. Once the pressure has been isolated, disconnect the air supply hose from
the air tool.
3. Shut down the compressor at the end of the work session.
STORAGE
If the tool is to be stored, or is idle for longer than 24 hours, run a few drops of
CLARKE air line oil into the air inlet, and run the tool for 5 seconds in order to
lubricate the internal parts.
When not in use, disconnect from air supply, clean the tools and store in a
safe, dry place. When storing, replace the blanking plug to the air inlet once
the airline is disconnected.
Avoid storing air tool s where the temperature is below 0
o
C.
Summary of Contents for X-PRO CAT208
Page 24: ......
