8
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
INSTALLING THE COLLET
1. Select the grinding stone you require.
2. Two collets of different sizes are
provided. Select whichever fits
the shank of the stone you have
chosen.
• The larger collet may already
be installed in the grinder.
3. If another collet is to be used,
undo the screw cap completely
and pull out the collet from the
collet seat. Replace it with the
new collet and screw the cap loosely back on.
FITTING THE GRINDING STONE
IMPORTANT: Never use chipped or cracked grindstones.
1. Slip the shank of the chosen stone
into the collet and tighten the
screw cap finger tight.
2. Place the smaller of the two
wrenches over the collet seat to
stop the tool from rotating.
3. Use the larger wrench to fully
tighten the collet and grip the
stone in position as shown.
ADJUSTING THE SPEED
1. Set the tool speed by rotating the
control to one of the four settings.
• The numbers on the speed
control knob indicate the
speed setting when aligned
with the reference mark on the
air inlet. Speeds available are
(+/-10%):
1
11,000 rpm
2
15,000 rpm
3
18,000 rpm
4
20,000 rpm
Summary of Contents for X-Pro CAT206
Page 16: ......
