6
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
A build-up of moisture or oil in the air compressor will accelerate wear and
corrosion in the tool. ensure any moisture is drained from the compressor daily
and the inlet filter is kept clean.
If an unusually long air hose is required, (over 8 metres), the line pressure or the
hose inside diameter may need to be increased. The air hose must be rated at
least 150% of the maximum operating pressure of the air tool.
Never exceed the maximum operating pressure for the tool. It is
recommended that air pressure to this tool does not exceed 90 psi at the tool
when running. Higher pressures and unclean air will shorten the life of the tool
due to faster wear and is a possible safety hazard.
OVERVIEW
When opening the carton for the first time, check that all the items are
present. Any damage or deficiency should be reported to your CLARKE dealer
immediately.
NO DESCRIPTION
NO DESCRIPTION
1
Right Angle Drive
5
Air Exhaust Deflector
2
Trigger
6
Inlet Connector
3
Air Inlet
7
11mm Collet Wrench
4
Speed Control
8
17mm Collet Wrench
Summary of Contents for X-Pro CAT206
Page 16: ......
