9
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
ADJUSTING THE SPEED
1. Set the tool speed by rotating the
control to one of the four settings.
• The numbers on the speed
control knob indicate the
speed setting when aligned
with the reference mark on the
air inlet.
• Speeds available are: 8300,
13000, 22000 or 25000 rpm (+/-
10%).
OPERATING THE DIE GRINDER
1. Slide the throttle locking lever
forward while squeezing the
trigger against the tool body.
2. Do not use pressure on the stone
as this will shorten its life.
3. Release the trigger to stop the
grinder.
• The tool will continue to rotate
for a short time after the trigger
has been released.
4. Always ensure the grinder has stopped before putting it down.
DISCONNECTING THE AIR SUPPLY
1. Do not disconnect the air hose until the supply is isolated at a shut-off
valve.
2. Once the pressure has been isolated, disconnect the air supply hose from
the air tool.
3. Shut down the compressor at the end of the work session.
Summary of Contents for X-Pro CAT201
Page 16: ......
