11
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
MAINTENANCE
DAILY
1. Before use, drain water from the air reservoir, air line and compressor.
2. If no line lubricator or mini oiler is used, ensure that oil is applied to the air
tool on a daily basis through the air inlet connection. Run a few drops of oil
through the tool before use. It may be entered into the air tool air inlet,
(ensuring the strainer is clear), or into the hose at the nearest connection to
the air supply.
3. This procedure should be repeated after every two to three hours of use or
at the start of the working day.
4. Keep the body of the tool clean and free from debris.
WEEKLY
1. Check the air inlet screen filter for
blockage and clean if necessary.
CLEANING
1. Grit or gum deposits inside an air
tool may reduce its efficiency.
2. After extensive use, remove the
inlet screen filter and flush out the
mechanism with gum solvent oil or
an equal mixture of CLARKE air-
line oil and paraffin. Allow to dry before use.
SERVICE AND REPAIR
1. If the air tool runs erratically or becomes inefficient although the air supply
is in good order, it may be necessary to dismantle the air motor and
replace any worn or damaged parts. Such servicing and repair work
should be carried out by a qualified service technician.
2. If the air tool still runs erratically or becomes inefficient, and the air supply is
of good quality, it may be necessary to dismantle the air motor and
replace worn or damaged parts.
WARNING: MAKE SURE THAT THE AIR TOOL IS DISCONNECTED FROM THE
AIR SUPPLY BEFORE STARTING ANY CLEANING OR MAINTENANCE.
Summary of Contents for X-Pro CAT201
Page 16: ......
