7
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
BEFORE USE
NOTE:
Ensure the compressor is turned off.
1. Remove the plastic blanking plug from the air inlet connection.
2. Pour 2-3 drops of CLARKE airline oil into the oil filling port. This should be
done regardless of whether or not a lubricated air supply is to be used.
3. If required, connect an in-line mini oiler to the tool.
• A mini oiler helps to prolong the life of any air tool.
4. If a mini-oiler is not being used, run
a few drops of oil through the tool
before use. It can be entered
through the airline connector or
via the hose at the nearest
connection to the air supply.
5. Connect a suitable hose as shown
or use the snap connector
supplied to connect directly to the
hose.
6. Connect the other end of the hose to the compressor.
7. Turn on the air supply and check for air leaks. Rectify any found before
proceeding.
• PTFE tape may be useful for sealing threaded connections.
8. If using a mini oiler, place a sheet of paper next the exhaust port and hold
the throttle open for approximately 30 seconds. The oil volume is correctly
set when a light stain of oil can be seen on the paper. Excessive oil should
be avoided.
Your impact wrench is now ready for use.
You can fit a whip hose with a quick fit coupling if required, available from
your CLARKE dealer.
WARNING: COMPRESSED AIR CAN BE DANGEROUS. ENSURE THAT YOU
ARE FAMILIAR WITH ALL PRECAUTIONS RELATING TO THE USE OF AIR
COMPRESSORS AND COMPRESSED AIR SUPPLY.
Summary of Contents for X-Pro CAT198
Page 16: ......
