11
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
CLEANING & OVERHAUL
1. If the wrench becomes sluggish and the air supply is of good quality, it may
be necessary to replace worn or damaged parts.
2. Grit or gum deposits in the
mechanism may eventually
reduce efficiency. This condition
can be corrected by cleaning the
air inlet filter and flushing out the
tool with gum solvent oil or an
equal mixture of SAE No10 oil and
paraffin.
3. Failing this, the tool may be
dismantled by unfastening the
bolts and removing the rear cover
prior to replacing any worn or damaged parts. You may prefer to take the
tool to your Clarke dealer if internal maintenance is required.
4. While is a dismantled state, it may be desirable to grease the hammer
mechanism and applying a small amount of good quality bearing grease.
• This may be better left to your Clarke dealer.
STORAGE
If the tool is to be stored or is idle for longer than 24 hours, run a few drops of
Clarke air-line oil into the air inlet and depress the trigger in order to lubricate
the internal parts.
When not in use, the tool should be disconnected from the air supply and
stored in a dry place out of the reach of children. Avoid storing in a damp
environment.
Summary of Contents for X-Pro CAT163
Page 16: ......
