17
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
OPERATION
ON/OFF SWITCH
1. To turn the saw on, press the
green button “I”.
• Wait for the blade to reach its
maximum speed before
commencing with the cut.
2. To turn the machine off again,
press the red button “0”.
NOTE:
The blade will spin for several
seconds after the machine is
switched off.
MOTOR BRAKE
The motor is fitted with a brake which should stop the saw blade in under 10
seconds.
If this time is exceeded, the brake must be repaired by an authorised service
centre.
A saw with a defective brake must not be used.
CAUTION: BEFORE STARTING UP THE SAW ALWAYS CHECK THE
FOLLOWING POINTS:
1. Is the saw blade firmly tightened?
2. Are all the locking levers firmly locked?
3. Is the riving knife aligned with the saw blade?
4. Is the saw blade guard fitted?
5. Make sure that the fences are not touching the saw blade.
6. Can the saw blade rotate freely?
7. Are there any wood pieces jammed between the saw blade and
the table insert?
8. Have all loose workpieces been removed from the table saw?
9. Have all the setting tools been removed?
10. Wear protective goggles, ear protection and dust mask.
Summary of Contents for Woodworker CTS14
Page 28: ......
