14
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
3. Take off the outer flange and
remove the old saw blade.
• Replacement blades are
available from our parts
department (part number
NHECTS14115).
4. Clean the blade flanges
thoroughly before fitting the new
blade.
5. Mount and fasten the new blade
in reverse order.
IMPORTANT: Note the running direction. The cutting angle of the teeth must
point in the running direction, i.e. forwards (see the arrow on the blade
guard).
6. Loosen the bolts that hold the
riving knife and adjust the riving
knife position until the distance
between the blade and the riving
knife is between 3-5 mm.
7. Retighten the bolts.
8. Replace the table insert.
9. Replace the saw blade guard.
10. Check to make sure that all
components are properly
mounted and in good working
condition before you begin
working with the saw again.
WARNING: RESET THE RIVING KNIFE EACH TIME THE SAW BLADE IS
REPLACED.
Summary of Contents for Woodworker CTS14
Page 28: ......
