7
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
MAINTENANCE
INSPECTION AND STORAGE
1. A visual inspection should be made before each use of the press, checking
for leaking hydraulic fluid and damaged, loose, or missing parts.
2. Owners and/or users should be aware that repair of this equipment requires
specialised knowledge and facilities. It is recommended that a thorough
annual inspection of the press be made and that any defective parts be
replaced with genuine Clarke parts.
3. Any press which appears to be damaged in any way, is found to be badly
worn, or operates abnormally SHOULD BE REMOVED FROM SERVICE until
the necessary repairs are made.
4. If the press is not to be used for any length of time, store it with the ram
piston withdrawn and the operating handle in the lowered position to
protect the moving parts.
PERIODICALLY
1. Check the frame to make sure all bolts are tight and inspect for cracked
welds, bent, loose or missing parts.
2. Check the hydraulic connections for leaks. Replace or properly repair any
damaged or leaking hydraulic components before using. In the event of
leaking seals, oil can be topped up via the plug on the end of the pump.
Oil should be level with the bottom of the hole. If necessary top up with
CLARKE hydraulic oil, part no 3050830. This task is carried out with the ram
fully retracted.
3. If any rust is apparent it must be removed completely and the paint
restored.
DE-COMMISSIONING THE PRODUCT
Should the product become completely unserviceable and require disposal,
draw off the oil into an approved container and dispose of the product and
the oil according to local regulations.
Summary of Contents for STRONG-ARM 7613025
Page 12: ......
