EN
ENGLISH
-10- FORM NO. 71280A
Clarke
®
Operator's Manual (EN) - Ultra Speed Burnisher
HOW TO CORRECT PROBLEMS IN THE MACHINE
Problem
Cause
Action
The machine will not run.
The machine may not have any power.
Make sure the machine is connected to the
correct voltage and frequency and that all
connections are tight or,
Make sure the machine is plugged in.
The power cord may be damaged.
Contact an authorized service person
The pad is worn or dirty.
Clean the pad. If the pad is worn, replace it.
The machine will not start.
The machine may have no power.
Make sure the machine is connected to the
correct voltage and frequency and that all
connections are tight or,
Make sure the machine is plugged in.
The brush warning light illuminates.
The carbon brushes need replacing.
Contact an authorized service person.
The machine is vibrating excessively.
The pad is not installed correctly.
Remove the pad. Install the pad correctly.
Center the pad properly.
The pad is worn or damaged.
Install a new pad.
The pad is defective.
Inspect and install a new pad.
https://harrissupplyind.com - To Order Parts Call 608-268-8080
