Clarke PIONEER 220, Operating & Maintenance Instructions

Page: 8 / 24

8
ELECTRICAL CONNECTIONS
WARNING! Read these electrical safety instructions thoroughly
before connecting the product to the mains supply.
Before switching the machine on, ensure that the voltage of your electricity
supply is the same as that indicated on the rating plate. These products are
designed to operate on either a domestic 230 VAC 50Hz supply (2320220) or
an earthed 110VAC 50Hz power supply (2320221). Connecting the
compressor to any other power source may cause damage.
This product may be fitted with a non-rewireable plug. If it is necessary to
change the fuse in the plug, the fuse cover must be refitted. If the fuse cover
becomes lost or damaged, the plug must not be used until a suitable
replacement is obtained.
If the plug has to be changed because it is not suitable for your socket, or
due to damage, it should be cut off and a replacement fitted, following the
wiring instructions shown below. The old plug must be disposed of safely, as
insertion into a mains socket could cause an electrical hazard.
WARNING! The wires in the power cable of this product are
coloured in accordance with the following code:
Blue = Neutral Brown = Live Yellow and Green = Earth
If the colours of the wires in the power cable of this product do not
correspond with the terminal markings of your plug, proceed as follows.
• The wire which is coloured Blue must be connected to the terminal which
is marked N or coloured Black .
• The wire which is coloured Brown must be connected to the terminal
which is marked L or coloured Red .
• The wire which is coloured Yellow and Green must be connected to the
terminal which is marked E or or coloured Green .
Plug must be BS1363/A approved
Earth Always fit a 13 Amp fuse.
(Green and Yellow)
Neutral Live
(Blue) (Brown)
Ensure that the outer sheath of the cable is firmly held by the clamp