Clarke PIONEER 220, Operating & Maintenance Instructions

Page: 11 / 24

11
PREPARATION FOR USE
WARNING: Before using the compressor, make sure that you have
read and understood the safety instructions.
UNPACKING
Take care when lifting the compressor from the packaging and obtain
assistance if necessary to avoid personal injury or damage to the machine.
Always use the handle and frame, with one hand under the tank if required.
CAUTION! NEVER TAKE THE WEIGHT OF THE COMPRESSOR BY HOLDING
THE PRESSURE CONTROL SWITCH.
After removing the compressor from its packaging, check that it has not
been damaged in transit.
MOVING THE COMPRESSOR
When moving the compressor;
• Always use the handle.
• Do not lift by (or place a strain on) the airline fittings or hoses.
• Take care when moving the compressor to avoid damaging the
valves or fittings.
• Always ensure it is switched off and disconnect from the mains
power supply.
POSITIONING THE COMPRESSOR
This compressor should be positioned on a stable, flat surface .
Note: the compressor should not be operated on a steep slope or floor
angle of greater than 15
O .
If the compressor is placed on a shelf or surface raised off the ground, it
should be secured appropriately to prevent it from falling off during use.
Do not cover or box in the compressor. Always position it with good all-round
air ventilation.
CONNECTION AND START-UP
Before connecting your compressor to the mains supply, check the
following:-
• The correct mains supply voltage is available for the product; either
230V (2320220) or 110V (2320221).