Clarke MIG220TE, Operating & Maintenance Instructions

Page: 11 / 36

11
ELECTRICAL CONNECTIONS
WARNING! THIS APPLIANCE MUST BE EARTHED.
MIG 220TE & 255TEC
Connect the mains lead, through a suitably fused isolator switch, to a 230 Volt (50Hz) electrical
supply, having a fuse rating in accordance with that given in the specification chart on page 2. A
standard 13 Amp plug
MUST NOT be used with this machine.
IMPORTANT: The wires in the mains lead are coloured in accordance with the following
code:
Green & Yellow - Earth
Blue - Neutral
Brown - Live
As the colours of the flexible lead of this appliance may not correspond with the coloured
markings identifying terminals in your electrical supply, proceed as follows:
• Connect GREEN & YELLOW coloured cord to terminal marked with a letter
“E” or Earth symbol “ ” or coloured GREEN or GREEN & YELLOW.
• Connect BROWN cord to terminal marked with a letter “L” or coloured RED.
• Connect BLUE cord to terminal marked with a letter “N” or coloured BLACK.
MIG 270TE
This model is designed for use with a 400V three-phase supply, and should be connected
through a suitably fused isolator switch.
The GREEN or GREEN & YELLOW wire should be connected to the EARTH terminal or terminal
marked with “ ” symbol. The other two wires are for connection to the phase wires.
Cable Extensions:
IMPORTANT:
For extensions up to 10m, the size of the conductors MUST be at least the same size
as that used on the machine - 2.5mm
2
. It is NOT advised to use extensions greater
than this, but if it is absolutely necessary, the conductor size must be 4mm 2 up to a
maximum of 25m in length.
DANGER
NEVER OPERATE THIS MACHINE WITH THE SIDE PANELS PARTIALLY
OPENED OR COMPLETELY REMOVED