Clarke MA50 15B, Service Manual

Page: 38 / 87

37
Service Manual – MA50 15B Handle System
14. Re-install the triggers onto the trigger pins. Make sure the (2) triggers “mate” in the center where they push
against the switch button
15. Re-assemble the front cover assembly back onto the handle bar. Make sure all of the pins for the triggers
and handle adjust lever are aligned with the holes
NOTE: The communication cable must be routed under the triggers (between the plastic housing and the triggers)
in order for the handle cover assembly to be re-assembled properly.
16.
Re-assemble the handle covers
Handle Adjust Cable and Gears
1.
Drain both tanks completely
2.
Remove the Recovery Tank
3.
Disconnect the batteries
4. Remove the batteries as a “pack”
5. Fold the handle down over the machine
6. Remove the (8) screws that hold the rear cover to the handle. You will have to remove the rubber hand grips
to access (2) of the screws
Handle Cover
Screws
Handle Cover
Screws
Triggers out
of machine
Triggers in
machine