14
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
FAULT CODE DISPLAY
The digital display can show the following fault codes.
FAULT CODE
CAUSE
SOLUTION
FO:- Operation Error
1. Heater is switched on
before being plugged
in.
1. Disconnect from power
supply, switch off and
then plug in again
before switching on.
F1:- Photocell Error
1. No fuel
2. Fuel is contaminated
3. Photocell is dirty or
damaged.
4. Fuel filter is dirty.
5. Ignition error
1. Switch off and refill the
tank.
2. Switch off, empty and
refill the fuel tank. Clean
the filter with clean fuel.
3.Contact your dealer.
4. Clean filter.
5. Contact your dealer.
F2:- Temperature
Control Sensor error
1. Damaged cable
2. Sensor is damaged.
1. Contact your dealer.
2. Contact your dealer.
F3:-Thermostat Error
1. Internal parts over
heating.
2. Anti-tilting sensor
activated.
1. Turn the heater off and
wait until it has cooled
down.
2. Reposition heater on a
level surface.
LO
1. External temperature
below -9
o
C
1. Wait for normal
temperature conditions
CH
1. Air temperature over
55
o
C.
1. Wait for normal
temperature conditions
Summary of Contents for DEVIL IRD40B
Page 20: ......