11
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
FILLING THE FUEL TANK
Before re-fuelling, disconnect from
the power supply and allow to cool
down.
Fill the tank with clean, water-free
diesel oil. When refilling, inspect the
mesh filter inside the filler neck for any
trapped contamination and clean
out if necessary.
• When filling the heater, make
sure that the heater is level and
do not overfill. Use a funnel or can with a long filling spout.
Plug the heater into any suitably earthed mains power supply.
NOTE:
In cold weather, condensation may develop in the tank if the tank
is empty. Before filling the fuel tank for the first time or after
extended storage periods, vent the fuel tank of any moisture or
condensation.
POSITIONING THE HEATER
The heater must be located on a
hard, level surface to minimise the risk
of accidental tipping over or running
forward. Chock the wheels if there is
any possibility of movement.
Set the heater angle of inclination by
loosening and re-tightening the
positioning knobs on either side to
achieve the required angle of tilt.
This heater should not be used in
habitable areas.
MATERIAL CLEARANCES
It is important that the heater be positioned with at least 3 m clearance at the
front between the heater and any obstruction including walls or other
combustible surfaces. Always position the heater facing the centre of the
room. Never place any objects on, or against the heater.
Any equipment or workshop furniture should be a safe distance away as they
could be adversely affected by heat. When the heater is in use, periodically
monitor any buildup of heat on nearby surfaces.
Summary of Contents for DEVIL IRD40B
Page 20: ......