15
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
REPLACING THE BELT
1. Open the end cover and loosen
the four bolts shown in Fig 10.
•
This will enable the drive motor to
move and the drive belt to
become slack.
2. Remove the drive belt from the
drive pulleys.
3. Replacement is a reversal of the
removal procedure. Tension the
belt by pushing the motor
downwards before tightening the
bolts.
4. Re-secure the end cover.
•
The motor will not run if the cover
is not secured.
Please refer to TROUBLESHOOTING on page 16. If you are unable to rectify any
faults, please contact your local dealer or Clarke International Service
Department on 0208 988 7400 for assistance.
OPTIONAL ACCESSORIES
The following are available from your local Clarke supplier.
Cup Turning Chuck
6500676
Screw Chuck
6500677
4-Jaw Independent Lathe Chuck
6500678
6” Faceplate
6500679
8 Piece Chisel Set
6500649
Summary of Contents for CWL1000B
Page 20: ......