ASSEMBLY
5
A. CSA10F
Fig.1
HYDRAULIC PUMP/RAM OPERATION
Ensure the press and its components
suffered no damage during transit.
Should any damage be apparent,
contact your Clarke dealer
immediately.
1.
Attach the feet and foot struts
to the side supports using the
nuts, bolts and washers
provided, leaving them finger
tight.
2.
Raise the assembly and rock it
to ensure that no part is under
stress and that the structure is
completely stable before
tightening all nuts securely.
3.
Feed the ram assembly down
through the hole in the top
plate and screw it fully into the
threaded hole in the bottom
plate. The pressure gauge at
this point should be facing the
front.
4.
Attach the pump assembly to
the frame by hooking the front
edge into the recess in one
end of the pump platform and
securing at the opposite end
with the screws provided.
Finally, screw on the hose
assembly to the ram inlet.
Your Hydraulic Press is now ready
for use.
