11
FITTING AND REMOVING A DISC
1. Make sure the disc guard is fitted before you fit any cutting/grinding disc.
2. Press and hold the spindle lock as
shown on the right.
NOTE:
You may need to turn the
spindle by hand to fully
engage the spindle lock.
3. Use the pin spanner supplied to
remove the threaded lock
washer.
4. Make sure that the mounting
washer is fitted correctly with the
raised circular section pointing outwards as shown and the flat section on
the opposite side engages with the flat section on the spindle.
5. Place the grinding disc over the
spindle and on top of the inner
flange.
• Place the disc onto the spindle
as shown.
• Make sure that the disc is
properly located on the inner
flange.
6. Place the threaded lock washer
over the spindle
• For standard discs make sure that the raised section of the threaded
lock washer is pointing towards the disc.
• When using thin discs, the threaded lock washer can be reversed so
that the raised section is pointing away from the disc.
7. Press and hold the spindle lock and use the pin spanner to tighten the
threaded lock washer.
WARNING: MAKE SURE THAT THE ANGLE GRINDER IS SWITCHED OFF AND
UNPLUGGED FROM THE MAINS SUPPLY BEFORE FITTING OR REMOVING
ANY ACCESSORIES.
