17
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
CHECKING AND ADJUSTING THE BEVEL SETTINGS
1. Loosen the bevel clamp handle.
2. Press the saw head to the right to
ensure it is fully vertical and
tighten the bevel clamp handle.
3. Pull down the head until the
blade just enters the kerf plate.
90 DEGREE STOP ADJUSTMENT
4. Place a set square on the table
and up against the blade.
NOTE:
Do not touch the tips of the blade teeth with the square.
If adjustment is required, proceed as follows:
5. Loosen the locking nut and turn
the 90° stop screw in or out until
the blade is at 90° to the table.
6. Re-tighten the locking nut.
7. If the bevel pointer does not
indicate zero on the bevel scale,
loosen the screw that secures the
pointer and move the pointer as
necessary.
Summary of Contents for CMS210S
Page 28: ......
