8
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
Ensure you comply with all precautions regarding the use of compressed air,
and air compressor operation.
Inspect the abrasive media regularly. If badly contaminated, it should be
replaced. A hinged cover is provided at the base of the funnel to allow quick
draining of the media.
CHANGING THE FLUORESCENT TUBE
Ensure the transformer is disconnected from the power supply before opening
the door and cutting the two ties securing the lamp to its retaining clips.
Carefully pull the lamp from the retaining clips then hold the clear plastic
protective outer tube firmly and ease off the plastic end cover from the non-
wired end. (This may take a little persuasion and perseverance).
Once the end cover has been removed, hold the end cover at the opposite
end (the cable input end), and pull off the outer protective clear plastic tube.
The fluorescent tube is now fully revealed.
Pull off the end connector, which secures a wire to one of the pins, taking care
not to distort the aluminium reflector. Then pull off the wire secured by a plastic
sheath to one of the pins at the cable input end.
Assemble in reverse order, ensuring the wires are correctly held by the plastic
sheath at one end and the end connector at the other, with the reflector
correctly in position.
Re-fit the assembly into its retaining clips and test its operation by plugging the
transformer into the mains.
