5
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
ASSEMBLY
NOTE: PTFE tape is provided for use to ensure an airtight fit.
1. Lay the cabinet on its back and
attach the four legs using the M6
x12mm screws, flat washers and
nuts, ensuring the flat washers are
against the screw heads.
2. Fit the intake vent cover to the
cabinet.
3. Attach the pick-up tube to the
funnel as shown, using the M6 x
12mm screws provided.
4. If not already fitted, peel the
backing paper from the foam strip
and apply the strip to the edge of
the grid support. Trim the strip
accordingly.
5. Use a punch (or similar) to make
holes in the foam strip, at the bolt
holes.
6. Place the grid support on the
funnel flange and the grid into the
recess in the grid support, so that the pick-up tube protrudes through the
grid neatly. Do not use undue force.
7. Turn the cabinet on to its legs then
and with assistance, raise the
funnel to meet the underside of
the cabinet, ensuring the pickup
tube is at the front of the cabinet.
Bolt the funnel assembly to the
cabinet using the M6 x 20mm
screws with the nuts and flat
washers provided, ensuring the
flat washers are against the screw
heads.
8. Open the cabinet door and attach the air hose from the gun to the inlet
port on the front of the cabinet, then connect the pick-up hose from the
gun to the pick-up tube attached to the funnel, securing with the worm
drive clip provided.
9. Attach the shelf to the legs using the screws and nuts provided.
