25
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
ACCESSORIES
MILL CHUCK SET
Part Number: 7610866
A set comprising 7 collets, a chuck
and ‘C’ spanner.
Collet sizes:
• 4 mm
• 6 mm
• 8 mm
• 10 mm
• 12 mm
• 14 mm
• 16 mm
1. Insert the shank of the chuck into
the mill head spindle and screw on to the end of the draw bolt. Tighten the
draw bolt, holding the spindle steady by hand or by inserting the tommy
bar provided in the hole in the side of the head and into the spindle.
2. Unscrew and remove the end collar ‘A’, insert the appropriate collet and
reattach the end collar.
3. Insert the respective end mill into the collet and tighten the end collar using
the ‘C’ spanner.
4. To remove the chuck, undo the draw bolt a turn or two, then tap its’ head
using a mallet to break the seal.
HSS END MILL (2-FLUTED)
Part Number: 7610874
A set of 7 End Mills, of the following
sizes, for use with the Mill Chuck or
Collet Set.
• 4 mm
• 6 mm
• 8 mm
• 10 mm
• 12 mm
• 14 mm
• 16 mm
Summary of Contents for 7610860
Page 28: ......
