8
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
UNPACKING
The drill press is delivered with the components shown on page 7.
Check the parts against the list on page 7. Should there be any deficiencies or
damage, you should contact your CLARKE dealer immediately where the
product was originally purchased. Do not discard the packaging until the
machine is assembled. The packaging consists of cardboard and
appropriately marked materials which can be sent to a re-cycling facility.
To protect the machine parts from moisture, a protective coating of light
machine oil will have been applied to the outside surfaces. Remove any
excess with a paper towel.
Take care when lifting the head assembly, considering its weight.
ASSEMBLY
This machine is designed for bench mounting and before use, it should be
mounted and securely bolted to a strong, heavy workbench, of sufficient
height that you will be standing upright when working.
Ensure the work place is adequately lit, and that you will not be working in your
own shadow.
COLUMN TO BASE
Bolt the column to the base with the bolts and washers provided.
NOTE:
Ideally, the base with column attached, should be firmly bolted to
the workbench prior to the assembly of other components.
TABLE TO COLUMN
1. Thread the table locking handle
into the table support and leave it
loose at this stage.
2. Slide the table support with the
table, over the column as shown
in Fig 1, and allow it to rest against
the base.
Summary of Contents for 6505512
Page 24: ......
