13
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
USING THE MACHINE FOR SANDING
SETTING THE SANDER WORK REST
Slacken the wingnut that secures the
work rest in place and position the
rest so that it is adjacent to the belt
edge and at 90 degrees to the belts
surface with approximately 2 mm
clearance. Tighten the wingnut to
secure in position.
USING THE SANDING BELT
1. Switch the motor ON by pushing
the switch so that the “I” is
depressed, and allow the machine to reach full speed. To switch the motor
OFF push the switch so that the “0” is depressed.
2. Hold the workpiece firmly on the work rest and apply slight pressure to the
sanding belt, allowing the machine to do the work.
MAINTENANCE
GENERAL MAINTENANCE
Make sure that all components are tight and secure. ALWAYS have any
damaged or worn parts repaired or replaced by qualified service personnel.
DO NOT attempt to repair the bench grinder unless you are qualified to do so.
The drive motor and bearings are sealed units and require no regular
maintenance. Should you require assistance, contact your service agent.
The grinding stone will wear down with use and may well go out of true. Use
the dressing wheel or stone grader to correct the trueness and to remove
worn, glazed areas from the stone.
The stone will have a finite life expectancy dependant upon the nature of the
work being done. Periodically, make a note of the wheel diameter and
replace the (150mm dia) wheel if it reduces to as little as (130mm) in diameter.
WARNING: ENSURE THAT THE WORKING POSITION ADOPTED DOES NOT
CAUSE OPERATOR FATIGUE WHICH MAY LEAD TO LOSS OF CONTROL OF
THE WORKPIECE BEING SANDED.
WARNING: THE SANDING BELT WILL CONTINUE TO ROTATE BRIEFLY AFTER
THE OFF SWITCH HAS BEEN PRESSED.
Summary of Contents for 6502130
Page 24: ......
