21
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
3. Using the open spanner and hex
key provided, hold the spindle to
prevent the motor from turning
and undo the saw blade securing
nut (normal thread).
4. Remove the outer retaining disc
followed by the saw blade by
lifting it clear of the motor shaft
and carefully withdrawing it from
above.
5. Replace in reverse order ensuring the saw blade teeth face downwards at
the front of the table.
• The arrow on the face of the blade will show the rotation to be
anticlockwise.
6. Hold the blade firmly when tightening the centre nut, taking care to avoid
injuring your hand on the sharp teeth.
IMPORTANT: Note the running direction. The cutting angle of the teeth must
point in the running direction, i.e. forwards (see arrow on the blade guard
).
7. Check that the riving knife lines up with the saw blade.
8. Refit the table insert and the transparent blade guard.
9. Check that all components are properly mounted and in good working
condition before you begin working with the saw again.
Summary of Contents for 6500752
Page 28: ......
