Clarke 6500685, Operating & Maintenance Instructions

Page: 18 / 32

MAKING STANDARD CUTS
1. THE ROUGHING OFF-CUT
Reducing a square or odd shaped workpiece
down to a cylinder of approximate size for finish
tur ning is called roughing-off. Faceplate
turnings and large diameter spindles should
first be par tly reduced by sawing , but small
spindles are easily turned down entirely with the
large (3/4”) gouge.
Start the first cut about 50mm from tailstock and
then run it toward the tailstock and off the end
of the workpiece.
Next, star t another cut 50mm nearer the
headstock and run it also toward tailstock to
merge with first cut.
Continue in this manner until 50mm to 100mm
from the headstock end, then reverse the
direction of tool travel and work one or two cuts
in succession toward the headstock and off this
end of the workpiece.
Never start a cut directly at the end. If the chisel
catches the end, it will damage the workpiece.
Never take long cuts while corners remain on
the work, as this tends to tear long slivers from
the corners.
The first series of cuts should not be too deep. It
is better to partially reduce the work to a cylinder
along its complete length, then start a second
series of cuts to reduce it to a cylinder. Once a
cylinder has been formed, step the lathe up to
its next fastest speed. Further reductions in size
can now be carried out by cutting as deeply
18
as desired at any spot along the work.
At this stage long cuts from the centre of either
end can also be taken. Roughing-off generally
is continued until the cylinder is approximately
3mm larger than the desired finished size.
Roundness can be tested by laying the gouge
on top of the work - it will not ride up and down
when cylinder is perfectly round.
2. ROUGH-CUTTING TO SIZE
Fig. 26
Fig. 27
Fig. 25
The roughing-off cut can be made to
accurately size the cylinder to a given diameter.
Another method is to make a number of sizing
cuts at intervals along the work, then use the
gouge to reduce the whole cylinder down to
the diameter indicated by these cuts.
3. MAKING SIZING CUTS
Sizing cuts are useful to establish approximate
finish-size diameters at various points along a
workpiece. The work can then be turned down
to the diameters indicated and be ready for
finishing.
Diameters for sizing cuts should be planned to
be about 3mm greater than the desired finished
diameters.
A sizing cut is made with the parting tool.
Hold the tool in one hand and use the other
hand to hold an outside calliper, preset to the
desired sizing-cut diameter.
As the cut nears completion, lower the chisel
point more and more into a scraping position.
When the callipers slip over the workpiece at
the cut, the cut is finished.
4. SMOOTHING A CYLINDER
The final 3mm can be removed in two ways.
Either use the 3/4” skew, working from the centre
toward both ends and taking lighter and lighter
cuts until finished.