18
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
CHANGING THE DISC
1. Remove the screws and lift away
the drive cover as shown then
peel the abrasive disc from the
faceplate.
2. Clean any residual adhesive from
the faceplate and refit a new
abrasive disc, taking great care
that it is central. Ensure it is evenly
attached across its surface.
3. When satisfied, replace the drive
cover.
FAULTFINDING
SANDER IS OVERHEATING
Overloading the machine will cause overheating. do not apply excessive
pressure when working. The motor may over heat if covered in dust which can
be blown out with compressed air. Always wear eye protection and a dust
mask when using compressed air.
EXCESSIVE MOTOR SPARKING OCCURS
This indicates worn brushes. This problem is quickly remedied but you should
consult your CLARKE dealer for parts and advice.
SANDER DOES NOT OPERATE WHEN SWITCHED ON
Check to ensure the fuse is sound and replace if necessary. If the fuse is sound
or blows repeatedly, consult your CLARKE dealer.
POOR ABRASION
If the sander is not removing material efficiently, check the sanding sheet. If
the abrasive is worn down replace the sheet. The sanding sheet must always
Summary of Contents for 6500421
Page 24: ......
