13
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
THE CONTROL PANEL
1. Welding Thickness Guide. Use this
table as an initial guide to setting
the welder and adjust for the best
quality weld.
2.
Power Indicator Lamp
. This will light
when the power is switched on.
3.
Thermal overload light.
If the duty
cycle is exceeded as a result of
welding too long with a high
current, the yellow overload light
will illuminate and the welder will turn off. When the welder has cooled
down (approx. 5 to 10 minutes), the power will be restored and welding
can recommence.
4.
Output Control Voltage.
Adjust the control according to the metal
thickness.
5.
Wire speed control knob.
As a general rule, a higher current requires a
higher wire speed.
PREPARATION FOR USE
MOUNTING THE WELDING WIRE SPOOL
NOTE:
Spools of welding wire are available from your CLARKE dealer.
1. Open the side panel.
2. Remove the retaining wingnut,
washer and retaining disc.
3. Fit the spool of welding wire (not
supplied) over the spindle so that
it compresses the spring.
• DO NOT release the tension on
the wire as it will unravel
causing feeding problems later.
• The wire will feed off the spool from the top of the reel.
Warning: Ensure that the welder is not connected to the mains supply.
Summary of Contents for 6015610
Page 28: ......
