10
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
OPERATION
1. Switch the machine on by
pressing the green (I) switch on
the motor. Stop by pressing the
red (O) switch.
2. Introduce water first, to prevent
the mixer from clogging.
3. Add cement as required.
4. Add aggregate etc.
• Do not load the drum when the
machine is switched off. Always set the machine running before
filling.
• Do not stop and start the mixer while there is a heavy weight of
material inside the drum as the extra strain could be harmfull to the
motor and gearbox.
• Keep the drum rotating while emptying the mixture.
5. When emptying, grip both
handles firmly and tip the mixer
forward.
6. Lock it in the forward position by
engaging the axle clip shown.
• Only discharge the mixer when
a suitable recepticle for the
material is in position.
• Do not operate this machine
on a steep gradient. Always
stand the mixer on firm, level ground where it cannot tip over.
• Always keep water well away from the motor and other electrical
components.
It is essential that the mixer is kept clean. Dried cement inside the drum will be
very difficult to remove. For the mixer to perform at its best it must be
thoroughly cleaned after every use.
WARNING: REMEMBER, THE CENTRE OF GRAVITY OF THE LOADED
MIXER MAY PRESENT A HAZARD WHEN OPERATING ON UNEVEN
GROUND.
