24
disarming
Press
to disarm the system. The vehicle’s lights will flash
twice, the doors will unlock, the siren will chirp twice and the
status LED will turn off. The transceiver will beep twice (or
vibrate), and the disarm icon (29) will be displayed on the LCD.
If the siren chirps and the transceiver beeps four or five times
when disarming, the system is reporting a triggered response or
the false alarm prevention circuitry was activated while armed.
Refer to the Diagnostic section of this manual for information
about disarm diagnostics and how to interpret them.
silence alarm without disarming
This a feature makes it possible to silence and reset the system
while it is triggered, without disarming the system. If the system
is triggered and the siren has been sounding for longer than six
seconds, press any button on the transceiver to stop the page,
then press
on the transceiver to stop the trigger and return
the unit to the armed state. The system will not disarm, but
rather reset. This prevents you from disabling the system should
you wish to disarm it without visually checking the vehicle.
Pressing
after resetting the system will disarm the system.
➜
➜
note:
Remote Sensor Bypass only applies to a single arm-
ing cycle. Once the system is disarmed and then re-
armed, all the zones will be active again.
