© 2006 Directed Electronics—all rights reserved
27
3.
Transmit.
While
HOLDING
the
Program switch
, press the button on the transmitter that you
would like to control the selected receiver channel.
4.
Release.
Once the code is learned, the Program switch can be released.
You can advance from programming one channel to another by releasing the Program switch and tapping it to
advance steps and then holding it. For instance: You have programmed Channel One and you want to program
Channel Two. Release the Program switch. Press it one time and release it to advance from Channel One to
Channel Two. Now, press and
HOLD
the Program switch. The LED will flash two times. As before, do not release
it.
If you want to program Channel Three after programming Channel One, release the Program switch, press it twice
and release it to advance to Channel Three. Then press it once more and
HOLD
it. The LED will flash three times
to confirm it is ready to receive the code from the transmitter.
Learn Routine will be exited if:
■
Ignition is turned off.
■
Program switch is pressed too many times.
■
More than 25 seconds elapses between programming steps.
CHANNEL NUMBER
FUNCTION
1
Auto-Learn*
2
Lock/Unlock
3
Channel 2 output
4
remote engine start
5
Turbo/Short Run
6
Timer Mode
7
Defogger Control
8
Delete all Transmitters**
*NOTE:
For Auto Learn Configurations, see Transmitter Configurations section of this
guide.
**NOTE:
If any button from a known transmitter is programmed to Channel 8, all
transmitters will be erased from memory and will revert to the default feature set-
tings. This is useful in cases where the customer's transmitters are lost or stolen.
