50
NX700
English
Owner
’s ma
nua
l
❏
Setting the anti-theft function
(CATS)
“CATS” is the acronym of “Clarion Anti-Theft
System”. When you set a PIN code (called as
“Personal Code”), a theft is prevented by
disabling the operation of the unit at the theft.
In addition, set the Blink LED function to improve
the effect of the CATS function (see page 49).
Setting your Personal Code
Note:
•
Write down your Personal Code in case you forget
it.
Erasing the Personal Code
When the ENTER PERSONAL CODE
screen appears
The Personal Code screen will be displayed
when turning the ACC power on after performing
the following operations:
• The car battery was replaced.
• The backup power was cut off.
• The Reset button was pressed.
Note:
•
If you forgot your Personal Code, please consult
your dealer or an authorized Clarion service
center.
1. Enter your Personal Code currently set.
2. When the correct Personal Code is entered,
the unit will restart from the initial startup
screen.
Note:
•
When you enter a wrong Personal Code, the
message “Code Incorrect” is displayed and the
Personal Code entry is prohibited for a while. This
prohibited time is changed according to the
number of times of wrong code entry as follows:
•
1 to 6 times: 15 seconds
•
7 times or more: 15 minutes
3-1. Touch the [
System
] key to display the
System tab screen.
3-2. Touch the [
}
] key to display the next
screen.
3-3. Touch and hold the blank area just below
the [
]
] key of the System Check item for
more than 2 seconds.
The Personal Code screen appears.
• When a Personal Code is already set, the
Erase Code screen will appear. Retry this
operation after erasing the old Personal
Code.
3-4. Enter your desired 4-digit Personal Code by
touching the [
0
] to [
9
] keys, then touch the
[
ENT
] key.
• Touch the [
BS
] key when you make a
mistake in entering.
3-5. Enter the same Personal Code again for
confirmation, then touch and hold the [
ENT
]
key for more than 2 seconds.
The entered Personal Code will be set, and
it will return to the previous screen.
3-1. Touch the [
System
] key to display the
System tab screen.
3-2. Touch the [
}
] key to display the next
screen.
3-3. Touch and hold the blank area below the [
]
]
key of the System Check item for more than
2 seconds.
The Erase Code screen appears.
3-4. Enter the Personal Code currently set by
touching the [
0
] to [
9
] keys, then touch and
hold the [
ENT
] key for more than 2 seconds.
The message “
Personal Code has been
erased
” appears, and it will return to the
previous screen.