English
38
DUZ385SAT
8. ERROR DISPLAYS
If an error occurs, one of the following displays is displayed.
Take the measures described below to eliminate the problem.
If an error display other than the ones described above appears, press the reset button. If the problem
persists, turn off the power and consult your store of purchase.
Error Display
Cause
Measure
C
D
/M
P
3
/W
MA
/AAC
ERROR 2
A CD is caught inside the CD
deck and is not ejected.
This is a failure of CD deck’s mechanism and consult
your store of purchase.
ERROR 3
A CD cannot be played due
to scratches, etc.
Replace with a non-scratched, non-warped-disc.
ERROR 6
A CD is loaded upside-down
inside the CD deck and does
not play.
Eject the disc then reload it properly.
CD ch
ang
e
r
ERROR 2
A CD inside the CD changer
is not loaded.
This is a failure of CD changer’s mechanism and
consult your store of purchase.
ERROR 3
A CD inside the CD changer
cannot be played due to
scratches, etc.
Replace with a non-scratched, non-warped disc.
ERROR 6
A CD inside the CD changer
cannot be played because it
is loaded upside-down.
Eject the disc then reload it properly.
DVD ch
ang
e
r
ERROR 2
A DISC inside the DVD
changer cannot be played.
This is a failure of DVD mechanism and consult your
store of purchase.
ERROR 3
A DISC cannot be played due
to scratches, etc.
Retry or replace with a non-scratched, non-warped-
disc.
ERROR 6
A DISC inside the DVD
changer cannot be played
because it is loaded upside-
down.
Eject the disc then reload it properly.
ERROR P
Parental level error
Set the correct Parental level.
ERROR R
Region code error
Eject the disc and replace correct region code disc.
US
B/MTP/iPod
ERROR 2
The files are not proper MP3/
WMA/AAC format.
Use only properly encoded MP3/WMA/AAC files.
ERROR 3
(USB/MTP mode)
The MP3/WMA/AAC files are
improperly encoded.
Use only properly encoded MP3/WMA/AAC files.
ERROR 3
(iPod mode)
The iPod contains no audio
files.
Insert an iPod containing audio files.
ERROR 5
The connected devices are
not recognized.
Disconnect the device and reconnect.
BUS-PWR
Overcurrent detection.
Disconnect the devices and reconnect. If the devices
are still not recognized, try replacing with a different
devices.
HUB
The connected devices are
not recognized.
Disconnect the devices and reconnect. If the devices
are still not recognized, try replacing with a different
devices.
DUZ385SAT_EN.book Page 38 Friday, November 23, 2007 7:49 PM
