MARKER
ADJUST
MARKER
ADJUST
MARKER
ADJUST
MARKER
ADJUST
MARKER
SELECT
Ｐ１
20
English
● MARKER SELECTION
① Press MENU button on the monitor or SETUP button on the remote control four times, and
select MARKER SELECT menu.
② Press ▲ / ▼ button on the monitor or ◀/▶ button on the remote control, and switch marker
pattern.
※ Distance marker function setting is only possible when MARKER SETUP ON is selected on
CAM1, full screen mode.
７ｍ
５ｍ
３ｍ
１ｍ
Bumper position
(From bumper toward rear)
Vehicle width
■ CCD camera installation conditions
(distance marker input conditions)
(Unit：mm)
Marker No.
(Pattern)
Camera Install
Height
Vehicle
Width
Ｐ１
Ｐ２
Ｐ３
Ｐ４
Ｐ５
Ｐ６
Ｐ７
２，０００
２，２５０
２，５００
２，７５０
３，０００
３，２５０
３，５００
２，５００
２，３００
２，５００
● MARKER ADJUSTMENT (Adjusting the Bumper position)
① Press MENU button on the monitor or SETUP button on the remote control five times, select
MARKER ADJUST menu.
② Press MODE button on the monitor or ▲/▼ button on the remote control, select H / V.
(H: horizontal / V: vertical )
③ Press ▲ / ▼ button on the monitor or ◀/▶ button on the remote control, and switch marker
pattern. (H = −10〜＋10, V= −12〜＋12, Default setting: H=0, V=0)
④ After 10 seconds, set up screen disappears, and set up finishes.
※ If there is no button operation, set up screen disappears even during set up process.
