MIRROR SET
CAM1 NORMAL
CAM2 NORMAL
CAM3 NORMAL
CAM4 NORMAL
MARKER SETUP
ON
OFF
19
English
CAMERA MIRROR/NORMAL MODE SETTING
8
１） Press SETUP button on the remote control (or
MENU button on the monitor) twice to go into
OSD MENU「MIRROR SET」.
２） Select camera by pressing ▼ button on the
remote control (or MODE button on the
monitor) then set MIRROR/NORMAL mode by
pressing ◀/▶ button on the remote contrl (or
▲/▼ button on the monitor).
※ It is set NORMAL mode from the factory.
ON SCREEN DISTANCE MARKER SETTING
9
• The onscreen distance markers should be considered as a general reference to assist the driver
in assessing the distances depicted on the screen. The distance markers have been designed
based on the “CCD camera installation conditions” listed in the next section, but differences
in vehicle design and construction may result in the actual installation condition or location
being different from the conditions listed. In such cases, the display location should be set at the
closest marker No.
• Distance markers cannot be set if non Clarion cameras are used.
Warning
① Press MENU button on the monitor or SETUP button
on the remote control on CAM1, full screen mode.
② Press MODE button on the monitor or ▲/▼ button
on the remote control, and select MARKER SETUP ON.
Then, press ▲ button on the monitor or OK button on
the remote control.
• The markers may not indicate the exact position of the bumper, the vehicleʼs width or the
distance to the rear. Use as a reference only.
Caution
