Clare Controls CM-BT10-TXRX100, User Manual

Page: 9 / 20

HDBaseT Extender Set 100m User Guide 3
Figure 2: The Rx100 receiver
(1) ON Working status indicator of this device. When the receiver is on and
working properly, the green LED blinks.
(2) LINK HDBaseT link status indicator, green LED. It remains illuminated when
the device has a connection.
(3) OUT The LED remains illuminated when connected to a device that supports
HDCP and is working normally. The LED blinks when the device does
not support HDCP.
(4) POWER LED The red LED illuminates and stays on when power is connected.
(5) ETHERNET Built-in Ethernet connectivity. Connect any of the Ethernet ports found
on the transmitter or receiver for Internet access and to feed your
IP-enabled devices. You can also connect to an existing LAN to
integrate all IP-enabled devices connected to the Extender Set. When
properly connected, the yellow LED indicators blink and the green
indicators remain illuminated.
(6) HDBT IN Connects to the HDBaseT port on the receiver via a single Cat5e/Cat6
cable.
(7) HDMI OUT Connect to the HDMI display device.
(8) IR IN Infrared signal input. Collects infrared signals to be sent via HDBaseT to
the transmitter (Tx) IR OUT.
(9) IR OUT Infrared signal input. Outputs infrared signals received from the
transmitter (Tx) via HDBaseT.
(10) RS-232 RS-232 connector. Supports bi-directional RS-232 communication.
(11) 24 VDC Connects to the power supply.
(1) (2) (3) (4) (5) (6) (7) (8) (9) (10) (11)