Clare Controls CM-BT10-TXRX100, User Manual

Page: 12 / 20

6 HDBaseT Extender Set 100m User Guide
Figure 3: System diagram
Connection procedure
To connect the HDBaseT Extender Set 100m:
1. Connect HDMI from the source (such as Blu-ray DVD) to the HDMI IN port of the
transmitter using an HDMI cable.
2. Connect the HDBT OUT port of the transmitter to the HDBT IN port of the receiver
with a single CAT5e/CAT6 cable using TIA/EIA T568B terminations at each end.
3. Connect the HDMI OUT port of the receiver to an HDMI in port on the display
using an HDMI cable.
4. When using the bi-directional IR control, do the following:
a. Connect the IR emitter at either end to the IR TX port on either the
transmitter or the receiver.
b. When using a powered IR receiver, connect via a 3.5 mm stereo plug to the
IR RX on either the transmitter or the receiver.
5. When set as a LAN, use one of the four ETHERNET ports for Internet access. You
can then connect the remaining ports to computers.